FSCRMM85-S10C_200G QSFP56_SFP光模块_产品中心

FSCRMM85-S10C

QSFP56 200Gb/s SR4 100m DDM

产品特性：
Supports 212.5Gb/s aggregate bit rate
4x26.5625GBd(PAM4)electrical interface
VCSEL Transmitter
PIN and TIA array on the receiver side
Maximum link length of 100m on
OM4 Multimode Fiber (MMF)
Hot-pluggable QSFP56 footprint
Single MPO 12 receptacle
Low power Consumption
RoHS-6 compliant and lead-free
+3.3V single power supply
Support Digital Diagnostic Monitor interface
Case operating temperature: 0℃ ~ +70

立即咨询返回列表

产品概述产品特性技术规格

产品概述

I. 引导图

II. 引用说明

Pin	Symbol	Name/DFSCRiption	Ref.
1	GND	Ground	1
2	Tx2n	Transmitter Inverted Data Input
3	Tx2p	Transmitter Non-Inverted Data Input
4	GND	Ground	1
5	Tx4n	Transmitter Inverted Data Input
6	Tx4p	Transmitter Non-Inverted Data Input
7	GND	Ground	1
8	ModSe1L	Module Select
9	ResetL	Module Reset
10	Vcc Rx	+3.3V Power supply receiver
11	SCL	2-wire serial interface clock
12	SDA	2-wire serial interface data
13	GND	Ground	1
14	Rx3p	Receiver Non-Inverted Data Output
15	Rx3n	Receiver Inverted Data Output
16	GND	Ground	1
17	Rx1p	Receiver Non-Inverted Data Output
18	Rx1n	Receiver Inverted Data Output
19	GND	Ground	1
20	GND	Ground	1
21	Rx2n	Receiver Inverted Data Output
22	Rx2p	Receiver Non-Inverted Data Output
23	GND	Ground	1
24	Rx4n	Receiver Inverted Data Output
25	Rx4p	Receiver Non-Inverted Data Output
26	GND	Ground	1
27	ModPrSL	Module Present
28	IntL	Interrupt
29	Vcc Tx	+3.3V Power supply transmitter
30	Vcc1	+3.3V Power Supply
31	LPMode	Low Power Mode
32	GND	Ground	1
33	Tx3p	Transmitter Non-Inverted Data Input
34	Tx3n	Transmitter Inverted Data Input
35	GND	Ground	1
36	Tx1p	Transmitter Non-Inverted Data Input
37	Tx1n	Transmitter Inverted Data Input
38	GND	Ground	1

Note：Circuit ground is internally isolated from chassis ground.

III. 极限参数

Parameter	Symbol	Min.	Typ.	Max.	Unit	Ref.
Storage Temperature	TS	-40		85	ºC
Storage Ambient Humidity	HA	0		85	%
Maximum Supply Voltage	VCC	-0.5		3.6	V
Lead Soldering Temperature/Time	TSOLD			260/10	ºC/sec	1
Lead Soldering Temperature/Time	TSOLD			360/10	ºC/sec	2

Note:

1.Suitable for wave soldering.

2. Only for soldering by iron.

IV. 操作条件

Data Rate Spcifications	Symbol	Min.	Typ.	Max.	Unit	Ref.
Supply Voltage	Vcc	3.13	3.3	3.47	V
Baud Rate(per channel ) PAM4	BR		26.5625		GBd	1
Operating Case Temperature	Tc	0		70	℃
Link distance on OM3 MMF	d			70	meters
Link distance on OM4 MMF	d			100	meters

Notes:

1. Supports 200GBASE-SR4 per IEEE 802.3cd.

V. 光学特性

Parameter	Symbol	Min.	Typ.	Max.	Unit	Ref.
*Transmitter(per lane)*
Average Output Power per lane	POUT	-6.5		4	dBm
Outer Optical Modulation Amplitude per lane	OMAOUT	-4.5		3	dBm
Extinction Ratio	ER	3			dB
Center Wavelength	λC	840		860	nm
RMS Spectral Width	σ			0.6	nm
Launch power in OMAOUT minus TDECQ	PTDECQ	-5.9			dBm
Transmitter and dispersion eye closure (each lane)	TDECQ			4.5	dB
Transmitter OFF Output Power	POff			-30	dBm
Optical Return Loss Tolerance	ORLT			12	dB
*Receiver(per lane)*
Input Optical Wavelength	λIN	840		860	nm
Average Recevive Power per lane	Pin	-8.4		4	dBm
Receiver Power ( OMAOUT ) each lane	ROMA			3	dBm
Rx Sensitivity( OMAOUT ) per lane (SECQ=1.4 dB)	RSENS			-6.5	dBm	1
Stressed Rx Sensitivity(OMA) per lane	SRSENS			-3	dBm
Damage threshold	PDT	5			dBm
Receiver Reflectance	Rfl			-12	dBm
LOS Assert	LOSA	-30			dBm
LOS De-Assert	LOSD			-9	dBm
LOS Hysteresis	LOSH	0.5			dB

Note:

1. BER<2.4E-4,Pattern PRBS31Q.

VI. 电气特性

Parameter	Symbol	Min.	Typ.	Max.	Unit	Ref.
Supply Voltage	VCC 1, VCCTX, VCCRX	3.15		3.45	V
Power Dissipation	Pd			6	W
*Transmitter(per Lane)*
Input different impedance	Rin	90	100	110	Ω
Single ended input voltage tolerance	VinT	-0.3		4.0	V
Differential Input Voltage Amplitude	Vin,pp			900	mV
*Receiver (per Lane)*
Error Bit Rate	BER			2.4E-4
Output different impedance	Rout	90	100	110	Ω
Single-ended output voltage	VoutR	-0.3		4.0	V
Differential Output Voltage Amplitude	Vout,pp			900	mV

VII. 数字诊断功能

VIII. 推荐接口电路

IX. 产品尺寸 (Unit: mm)

产品特性

Supports 212.5Gb/s aggregate bit rate

4x26.5625GBd(PAM4)electrical interface

VCSEL Transmitter

PIN and TIA array on the receiver side

Maximum link length of 100m on

OM4 Multimode Fiber (MMF)

Hot-pluggable QSFP56 footprint

Single MPO 12 receptacle

Low power Consumption

RoHS-6 compliant and lead-free

+3.3V single power supply

Support Digital Diagnostic Monitor interface

Case operating temperature: 0℃ ~ +70 ℃

应用	标准
200GBASE-SR4 200G Ethernet	QSFP MSA.
	IEEE802.3cd
	SFF-8636
	RoHS

技术规格

Ordering Information

Part NO.

Bit Rate

(Gbps)

Laser

(nm)

Distance(m)

Media

DDMI

Connector

Temp(℃)

FSCRMM85-S10C

212.5

850

100

(OM4)

multi-mode fiber

YES

MPO 1X12

0~70